Strength of Material Lab

strength of material lab

Ultrasonic Flaw Detector

Ultrasonic Flaw Detector

This unit has a variable square wave pulsar to optimize the performance of transducers. Probe sensitivity is increased by pulse width variation.
1). Bench mounted unit.
2). Bright electro-luminescent display.
3). Frequency range 5 bands 1MHz to 35 MHz
4). Test modes pulse echo and transmit/receive.
5). Update rate 60Hz.
6). 5 Measurement modes.
7). Selectable damping.
8). Continuously variable probe zero.
9.) Test range 1 to 20000mm at steel velocity.
10.) Gain 0 to 110dB.
11.) Panel memory 20 stored calibrations.
12.) Thickness logging 2000 storage readings.
13.) RS232 interface.
14.) Battery operation/Mains operation power pack.
15.) Transducer sockets BNC or LEMO.
16.) Aluminum Carry case.
17.) Operating temperature-10 to 55 degree C.
18.) 4.3 MHz crystal single angle medium damped.
19.) 2.25 MHz crystal single angle medium damped.
20.) 5 MHz 2 x 8 x 4 crystal twin contact medium damped.
21.) 2.25 MHz 2 x 8 x 4 crystal twin contact medium damped.
22.) 1.25 MHz 2 x 8 x 4 crystal twin contact medium damped.
23.) 10 MHz 10mm dia. crystal single contact medium damped.
24.) 2.25 MHz 10mm dia. crystal single contact high damped.
25.) 5 MHz 10mm dia. crystal single contact high damped.
26.) Single probe cable 2 meters.
27.) Twin probe cable 2 meters.
28.) Printer cable.
29.) PC cable.
30.) Calibration blocks welding.
31.) Storage and recall software